Kohler SV810-840 Service Manual page 79

condition is corrected.
Problem Possible Fault
Starter
Does Not
Energize
Starter Switch
or Solenoid
Starter
Energizes
but Turns
Slowly
Transmission
Operation - Inertia Drive Starters
cranks the engine.
than the starter armature and drive pinion. This
moves the drive pinion out of mesh with the ring
removed from the starter, the armature stops rotating
and the drive pinion is held in the retracted position
Battery
Wiring
insulation.
cranks normally, replace the faulty components.
Starters: Perform individual solenoid test procedure. See page
Battery
Brushes
in neutral. This is especially important on equipment with
or
Engine
prevent resistance which could keep the engine from starting.
connecting rod, and piston.
Electrical System and Components
Starter Removal and Installation
starter removal and installation procedures.
Inertia Drive Electric Starters
and repair of the inertia drive, permanent magnet
electric starters.
Correction
Starter Drive Service
Every 500 hours
Section 7
7
7.23