Kohler SV810-840 Service Manual page 43

Figure 5-15. Fuel Bowl Removed from Carburetor.
necessary unless a Fuel Solenoid Kit
(obtained separately), is also being installed.
Discard all of the parts. The seat for the inlet
needle is not serviceable, and should not be
removed.
Figure 5-16. Removing Float and Inlet Needle.
removed, the main nozzle can be taken out
Fuel System and Governor
Figure 5-17. Main Jet and Slow Jet Removed.
4. Remove the two screws securing the top cover,
gasket, and ground lead (fuel solenoid-equipped
models). Discard the gasket and screws only.
screws and springs from the carburetor. Discard
the parts.
appropriate cleaning and installation
of the parts in the overhaul kit. Further
disassembly is not necessary. The
serviceable items and should not be
serviceable, however it should not be
removed unless a Choke Repair Kit will
be installed.
seats, etc., using a good commercially available
carburetor solvent. Use clean, dry compressed
air to blow out the internal channels and ports.
Inspect and thoroughly check the carburetor for
cracks, wear, or damage. Inspect the fuel inlet
seat for wear or damage. Check the spring loaded
choke plate to make sure it moves freely on the
If it has an accelerator pump that is not being
serviced at this time, prevent the cleaning solvent
from contacting the check valve and accelerator
pump components.
Section 5
5
5.11