Kohler SV810-840 Service Manual page 70

Section 7
Electrical System and Components
Test 5. Test the DSAM.
to the harness connection. Separate the connector
indicated, check the ground circuit
the harness connector terminal for a good
connection and crimp to the lead. Then trace
harness, key switch, etc., looking for any poor
connections, or faulty circuits.
do not feel snug, disconnect the lead, lightly
pinch the female terminal with a pliers, and
compound. Do not put any compound inside the
connectors.
replace that ignition module and recheck spark.
7.14
To Test - Using 25 761 40-S Tester
must
leads, isolating it from the main wiring
from the engine for clarity.
Figure 7-13.
Attach:
• tester lead to the
lead.
• tester lead to the
lead.
• Red tester lead to the red module lead.
• tester lead to the
• tester lead to the
module lead.
•
to the
Caution:
each other.
*IMPORTANT!
end of the tester housing, noting the last two
™).
module
module
module
or
module lead.