FlowLine DataView LI55 Series Quick Start Manual page 28

DataView™ LI55 Level Controller
|
RESETTING DATAVIEW™ TO FACTORY DEFAULT
To reset the controller to its factory default configuration, follow the below steps.
Press and hold MENU for 5 seconds and Setup (SEtuP) will appear.
1.
Press and hold MENU again for 3 seconds and Filter (FiLtEr) will appear.
2.
Press Up to scroll through the menu options until you reach Diagnostics (diAG).
3.
Press and hold Right for 3 seconds and Reset (rESEt) will appear. .
4.
Press ENTER and the controller will go through an initialization sequence, load its
5.
factory default configuration and return to the Run Mode.
28
Quick Start
QS301033 Rev C1