FlowLine DataView LI55 Series Quick Start Manual page 13

DataView™ LI55 Level Controller
Quick Start
|
USING DATAVIEW™
DataView™ is factory calibrated to read 4-20 mA input signals. The calibration is
certified to NIST standards.
Overview
All setup and configuration functions are performed through the front panel
interface. After the power and input signal connections have been completed
and verified, apply power to the controller.
The top line displays the level or volume in the tank. The bottom line displays the
units for the level or volume in the tank.
DataView™ has 7 preset units [Gallons (GAL), Liters (LitEr), Inches (IncH),
Feet (FEEt), Centimeters (crn), Meters (rnEtEr) and Percent (PErcnt)] and a
custom function [Custom (CuSt)] to configure other units up to 6
alphanumeric characters.
DataView™ uses a graphic system to create characters. While the letters
"m" and "w" are not included, they can be created by combining characters.
DataView™ has 1-8 alarm indicators. Indicators 1-4 are enabled by default.
When a relay expansion card (LI56-1400) is installed, indicators 5-8 become
available.
13
QS301033 Rev C1