FlowLine DataView LI55 Series Quick Start Manual page 15

DataView™ LI55 Level Controller
|
CONFIGURING DATAVIEW™
Follow the below six steps to configure DataView™ for your application. Note:
Not all models and configurations will require six steps.
1. Set Units of Operation (UnItS)
a.
2. Set Decimal Point (dEc Pt)
a.
3. Set SCALE (SCALE)
a.
4. Set Relays (rELAY)
a.
5. Set Analog Output (Aout)
a. This configures the repeater analog output. Note: This function is only
6. Set Password (Pass 1)
a. This configures a protective password to secure the controller
QS301033 Rev C1
This configures the units of operation and is the value that will appear on
the display.
This configures the location of the decimal point. For example, you can
configure the display to read to the 1/10th position, 1/100th position or
1/1000th position.
This configures the tank full and empty scale for the controller. For
example, 20 mA is typically a full tank and 4 mA is typically an empty
tank.
This configures the relay functions and set points where they will
energize and de-energize. Note: This function is only applicable to
models with relays.
applicable to models with repeaters.
setting.
Quick Start
15