Table of Contents
Advertisement
40X ZOOM IR PTZ DOME CAMERA USER GUIDE
Configuring Video Settings
This section describes how to configure camera properties (picture, exposure, white
balance, day and night, and lighting compensation) and video streaming properties
(format, resolution, frame rate, bit rate, and I-frame interval).
Configuring Video
You can configure video streaming properties on the Setting Camera Video Video.
The page is divided into two sections: Main Stream and Sub Stream. In the Sub Stream
section, two sub streams are configurable: Sub Stream 1 and Sub Stream 2. To enable a
sub stream, select one of the sub streams, and then select the Enable check box.
For each record type (General, Motion, Alarm), you can configure the encoding format,
resolution, frame rate, bit rate, and I-frame interval settings. You can also apply a
custom watermark to the main stream.
Encode Mode
In the Format box, select H.264B, H.264, H.264H, MJPEG, or H.265.
H.264: Main Profile. Uses less bandwidth than Baseline Profile at the same quality.
H.264B: Baseline Profile. Uses up to 50% less bandwidth than MPEG4 and up to 80%
H.264H: High Profile. Uses less bandwidth than Main Profile at the same quality.
MJPEG: Uses the most bandwidth but produces excellent image quality with access
H.265: High Efficiency Video Coding. Supports 4K resolution. Twice as efficient as H.264.
Smart Codec
Set Smart Codec to ON or OFF.
By taking reference frames and applying them to refreshed frames, Smart Codec
eliminates the need to transmit data for an unchanged image or parts of the image
where there is no movement. Used together with H.264, Smart Codec can lead to
32
less than MJPEG. Higher compression and lower quality than H.264.
Lower compression and higher quality than H.264.
to every image in the stream.
Advertisement
Table of Contents
