Configuring Snapshot - Honeywell HDZ402LIWV User Manual

storage savings of up to 60 percent and bandwidth savings of up to 40 percent over
H.264 alone.
Resolution
In the Resolution box, select a resolution from the list. The available options differ
between the main stream and sub streams.
Frame Rate
In the Frame Rate (FPS) box, select a frame rate within the available range (1–30 fps
for NTSC cameras; 1–25 fps for PAL cameras).
Bit Rate
In the Bit Rate Type box, select CBR or VBR.
CBR Constant bit rate. The bit rate remains constant (recommended for
Low bandwidth environments). Required if MJPEG compression is used.
VBR Variable bit rate. The bit rate changes according to the complexity of the scene.
Select a Quality level between 1 (lowest) and 6 (highest).
In the Bit Rate box, select a bit rate from the list using the Reference Bit Rate as a guide.
I-Frame Interval
In the I-Frame Interval box, enter a value between 1 and 150. The default I-frame
interval is two times the frame rate. For example, if the frame rate is 30 fps, the I-
frame interval will be 60.
Watermark
To apply a custom watermark to the main stream, select the Watermark Settings
check box. In the Watermark Text box, enter the watermark text. The text cannot have
any spaces but underscores (_), and hyphens (-) are acceptable.
Click Save to apply the settings.

Configuring Snapshot

You can configure snapshot properties on the Setting  Camera  Video  Snapshot
page.
Snapshot Type
Set the Snapshot Type to General or Event.
General: Snapshots are taken according to a user-defined schedule.
Event: Snapshots are taken when an alarm, motion detection, camera tampering, audio,
face detection, or system event occurs.
40X ZOOM IR PTZ DOME CAMERA USER GUIDE
33