Table of Contents
Advertisement
between 0 and 100 seconds. The system will only allow one alarm event
within this period.
6. Set Sensor Type to NO (normally open) or NC (normally closed),
depending on the alarm input type.
7. To start recording video when an alarm event is detected, select the Record check
box.
8. In the Record Delay field, enter the number of seconds that the system will
continue to record video after an alarm event has ended. Enter a value
between 10 and 300.
9. To generate an alarm output when an alarm event is detected, select the Alarm
Output
check box and select the alarm output(s) to be activated.
10. In the Alarm Delay field, enter the number of seconds that the system will
continue to generate an alarm output after an alarm event has ended. Enter a
value between 10 and 300.
11. To send an email notification when an alarm event is detected, select the
Send Email check box. Email settings must be configured in Setting
Network SMTP (Email).
12. To initiate a predefined preset, tour, or pattern when an alarm event is
detected, select the PTZ check box and select the desired action from the
Activation list.
13. To take a snapshot when an alarm event is detected, select the Snapshot check box.
For the snapshot to be attached to the email notification, the Attachment
check box must be selected in Setting Network SMTP(Email).
Note
14. Click Save to apply the settings.
Configuring Abnormality
You can configure system event settings (for SD card and network errors and
illegal login attempts).
Configuring SD Card
There are three types of SD card events:
No SD Card: There is no microSD card installed in the camera.
•
SD Card Error: The installed microSD card is not working.
•
Capacity Warning: The installed microSD card is full. You can configure settings for
•
each type of event.
40X ZOOM IR PTZ DOME CAMERA USER GUIDE
75
Advertisement
Table of Contents
