Functions And Settings; Basic; Remote Control - ProLights VORTEX VXBUBBLE User Manual

VXBUBBLE
6

- 2 - FUNCTIONS AND SETTINGS

2.1 Basic

Place the unit on a horizontal surface;
- Fill up the BUBBLE fluid container (BUBBLEFLUID series). If any fluid is spilt, wipe it off immediately with
a dry cloth. It must not get inside the unit.
- Connect the wireless control to the socket on the rear panel.
- Plug main power cord from the BUBBLE machine into the appropriate power supply socket.
- The machine is ready for use.
- Refer to the section of the manual: DMX mode or manual control.
WARNING: while filling up the BUBBLE fluid container (BUBBLEFLUID), the unit must not be connected. Dis-
connect the main plug from the socket first! The unit is not splash proof. If fluid accidentally gets inside the
unit, do not set the BUBBLE machine into operation; it must be cleaned and checked by skilled personnel
first.
2.2 Manual control
If no DMX control signal is present at the DMX INPUT, the unit can operate in manual mode.
Insert the plug of the power supply into the power supply socket of the back panel of the machine, turn the
power supply switch of the machine, ON/OFF to ON and then the red indication light on the control box will
be on (POWER).Turn the spin switch (BUBBLE ON/OFF) on the control box to ON, the red indication light on
the control box will be on and there is bubble spurting out.
Adjust the potentiometric knob (OUTPUT VOLUME) on the back panel of the bubble machine to control the
air fan system.
2.3 Wireless remote control
VXBUBBLE is equipped with a multi-channel wireless control system, employing a wired receiver and a
4-key wireless remote control.
Connect the KT-1 receiver to the control panel output, and then turn on the machine. The red LED located
on the KT-1 receiver will light up indicating that the machine is in preheating.
When the preheating process is finished and the machine is ready, the LED will light up to green. Now you
can control the machine through the wireless remote control.
The timer controller KT-1 is equipped with 4 dipswitches, located on the side, which are in numerical order
(1-4), corresponding to wireless remote control keys. The LED on the wireless remote control will light up
when you will press any button.
More Vortex machines can be controlled with a single remote control. Each of the keys (1-4) of the remote
control will activate the machines having the same values (1-4) enabled on KT-1 receiver (dipswitch ON
position, downward). To control more machines at the same time using a single key of the remote, just set
them on same channel (1-4).