Page 76
Figure 3-27: Sensor Configuration part 2
July 2019 – TD 304 OPERATING MANUAL – Doppler Current Profiler Sensor
In the second half of the
Configuration
menu you will find mainly
setting that will control the output
User Specified
If
is selected under
Output/Storage – Profile Parameters>Select
Profile Parameters
then the individual
selection in the next menu
Profile Parameters
will be valid. For all other
Select Profile Parameters
settings in
selections of parameters in
Profile Parameters
will be overruled.
NOTE!!
User Specified – Profile Parameters
Select Profile Parameter
are only valid when
is set to
User
Specified,
The selection for each property in these menus
will also be dependent on the mode setting
For the DCPS connected to a SeaGuardII or
SmartGuard it is possible to
Storage
or Output+Storage.
If set to
Off,
the sensor does not output data. If
set to Storage, the Datalogger only saves the
data to the SD-card (if inserted). If
Output+Storage
is selected, the Datalogger
saves the data to the SD-card and includes the
data in the real-time output from the Datalogger
(if real-time output is enabled).
More details on how to enable real-time data
output can be found in the TD 303, manual for
SeaGuardII platform, Chapter 6 and TD 293,
manual for SmartGuard.
System
User Specified –
the
User Specified –
select: Off,