Table of Contents
Advertisement
Page 34
Figure 2-2: AADI Real Time Collector connection settings
Click on the
Advanced Settings
shown below.
The
Advanced Settings
need to close the port, refer
Figure 2-3: Advanced connection setting
July 2019 – TD 304 OPERATING MANUAL – Doppler Current Profiler Sensor
in the right lower corner and select
are only accessible to change when the port is closed. If the settings are grey then you first
Open Port / Close Port.
Figure 2-4
. First enter a new
Refer Figure 2-2
Connection
Name, we recommend using
name and serial number. Select
in the dropdown menu under
and choose the correct COM-port on your
computer under
Port Name.
Baud Rate.
as
This is the default baud rate
on all DCPS sensors. The
to match the baud rate set in
Maintenance.
Connection
on the left side in the next window as
Refer to
Figure
2-3: AADI Real-Time
Collector uses a default setting that fits for
most Smart Sensor. However the DCPS
sensor outputs a large amount of data and
might have much longer response time
(depending on the configuration) than other
smart sensors. Some of the connection
settings might need to be changed. We
recommend using the settings as shown in
Figure 2-3.
After updating the
Settings,
click on
OK
to go back to the start screen.
Serial Port
Port
Setting,
Select
115200
Baud Rate
needs
User
Advanced Connection
Apply
OK
and
and then
Advertisement
Table of Contents
