Table of Contents
Advertisement
Page 62
Figure 3-3: AADI Real-Time Collector start up menu
Figure 3-4: AADI Real time Collector connection settings
Advanced Settings
Click on the
shown below.
The
Advanced Settings
need to close the port, refer
July 2019 – TD 304 OPERATING MANUAL – Doppler Current Profiler Sensor
in the right lower section and select
are only accessible to change when the port is closed. If the settings are grey then you first
Open Port / Close Port.
Figure 3-6
At first connection with AADI Real-Time Collector
the connection list will be emty. Click on the
New
button in the lower left corner to create a
new connection
NOTE: This only need to be done once. AADI
Real-Time Collector will keep the information for
later use and next time you might select it from
the connection list.
Select
USB
from the
Port Settings
3-4); and write a name in the
menu
(Figure
Connection Name
box (for i.e. SeaGuardII). We
recommend using product name and serial
number if you want to connect multiple
instruments to the same software.
Connection
on the left side in the next window as
drop down
Advertisement
Table of Contents
