Table of Contents
Advertisement
July 2019 – TD 304 OPERATING MANUAL – Doppler Current Profiler Sensor
Figure 3-26: Sensor Configuration part 1
System Configuration
is separated in 14
groups. The settings in these groups are
mainly used to configure the sensor and
control the output/ storage of data.
Refer chapter 1.7.3 for more information on
the properties in
System
If you change mode you might need to go
back to the Recorder panel and
Status
Stop Recorder
and or
can continue to configure.
Some of the settings are only available if
Acoustic Wave is enabled. The Acoustic
wave module is a licensed option. Older
units and units without Acoustic wave can
also be upgraded, either by user or at the
factory
The Mode setting will also influence some of
the alternatives in the rest of the session.
For more information on each property see
3.6.1
to 3.6.14.
chapter
.
Page 75
Configuration.
Refresh
before you
Advertisement
Table of Contents
