Aanderaa DCPS 5400 Operating Manual page 120

Page 120
East AutoBeam[cm/s]
Vertical Beam123[cm/s]
Vertical Beam124[cm/s]
Vertical Beam134[cm/s]
Vertical Beam234[cm/s]
Vertical AutoBeam[cm/s]
Beam1 Speed[cm/s]
Beam2 Speed[cm/s]
Beam3 Speed[cm/s]
Beam4 Speed[cm/s]
Beam1 Strength[dB]
Beam2 Strength[dB]
Beam3 Strength[dB]
Beam4 Strength[dB]
Beam1 Stdev[cm/s]
Beam2 Stdev[cm/s]
Beam3 Stdev[cm/s]
Beam4 Stdev[cm/s]
Cross Difference[cm/s]
Beam1 Correlation
Factor[cm/s]
Beam2 Correlation
Factor[cm/s]
Beam3 Correlation
Factor[cm/s]
Beam4 Correlation
Factor[cm/s]
July 2019 – TD 304 OPERATING MANUAL – Doppler Current Profiler Sensor
Set NE Speed Output(Off/Output) and Set AutoBeam Output(Off/Output)
From software version 8.2.1:Set AutoBeam Speed
Type(Polar/Rectangular/Polar+Rectangular/ Replace 4-Beam Data) and
Set AutoBeam Output(Off/Output) set to Rectangular and Output to be enabled
Set Vertical Speed Output(Off/Output) and Set 3-Beam Combination Output(Off/Output)
(both set to output to be enabled).
This is changed from software version 8.2.1. From this version only Set 3-Beam
Combination Output(Off/Output) affects the output of this parameter
Set Vertical Speed Output(Off/Output) and Set 3-Beam Combination Output(Off/Output)
(both set to output to be enabled).
This is changed from software version 8.2.1. From this version only Set 3-Beam
Combination Output(Off/Output) affects the output of this parameter
Set Vertical Speed Output(Off/Output) and Set 3-Beam Combination Output(Off/Output)
(both set to output to be enabled).
This is changed from software version 8.2.1. From this version only Set 3-Beam
Combination Output(Off/Output) affects the output of this parameter
Set Vertical Speed Output(Off/Output) and Set 3-Beam Combination Output(Off/Output)
(both set to output to be enabled).
This is changed from software version 8.2.1. From this version only Set 3-Beam
Combination Output(Off/Output) affects the output of this parameter
Set NE Speed Output(Off/Output) and Set AutoBeam Output(Off/Output)
From software version 8.2.1:
Set AutoBeam Output(Off/Output) and and Set Vertical Speed Output(Off/Output)
Set Beam Speed Output(Off/Output)
Set Beam Speed Output(Off/Output)
Set Beam Speed Output(Off/Output)
Set Beam Speed Output(Off/Output)
Set Beam Strength Output(Off/Output)
Set Beam Strength Output(Off/Output)
Set Beam Strength Output(Off/Output)
Set Beam Strength Output(Off/Output)
Set Std Dev Beam Speed Output(Off/Output)
Set Std Dev Beam Speed Output(Off/Output)
Set Std Dev Beam Speed Output(Off/Output)
Set Std Dev Beam Speed Output(Off/Output)
Set Cross Difference Output(Off/Output)
Set Bandwidth(Broadband)
Set Correlation Factor Output(Off/Output)
Set Bandwidth(Broadband)
Set Correlation Factor Output(Off/Output)
Set Bandwidth(Broadband)
Set Correlation Factor Output(Off/Output)
Set Bandwidth(Broadband)
Set Correlation Factor Output(Off/Output)