Aanderaa DCPS 5400 Operating Manual page 25

July 2019 – TD 304 OPERATING MANUAL – Doppler Current Profiler Sensor
C1 Enable
BOOL
Surface
Reference
ENUM
C1 Cell Size
C1 Distance
ENUM
first Cell
Center
C1 Number Of
ENUM
Cells
C1 Cell Center
ENUM
Spacing[m]
C2 Enable
BOOL
Column
C2 Enable
BOOL
Surface
Reference
ENUM
C2 Cell Size
C2 Distance
ENUM
first Cell
Center
C2 Number Of
ENUM
Cells
C2 Cell Center
ENUM
Spacing[m]
C3 Enable
BOOL
Column
C3 Enable
BOOL
Surface
Reference
ENUM
C3 Cell Size
Enables surface reference for Column 1. If not selected the column will
be instrument referenced.
1
compensate for tidal variations. Cannot be used it in combination with
downward orientation.
The Cell size setting for Column 1 in meter. Selectable from 0.5 to 5
1
meter. Default setting is 1 meter.
The distance to centre of first cell for Column 1 in meter, distance from
surface if surface referenced or sensor if not surface referenced.
1
Always sensor referenced if used upside down. Selectable from 1 to 70
meter. Default setting is 3 meter.
Number of Cells in Column 1, maximum 75 cells. Default setting is 45.
1
Spacing between two cells for Column 1 in meter. If spacing is equal to
cell size the two cells is next to each other. Spacing less than cell size
1
gives overlap and spacing more than cell size gives space between two
cells. Selectable from 0.1 to 30 meter. Default setting is 1 meter.
Enables Column 2 (Column 1 is always enabled)
1
Enables surface reference for Column 2. If not selected the column will
be instrument referenced.
1
compensate for tidal variations. Cannot be used it in combination with
downward orientation.
The Cell size setting for Column 2 in meter. Selectable from 0.5 to 5
1
meter. Default setting is 1 meter.
The distance to centre of first cell for Column 2 in meter, distance from
surface if surface referenced or sensor if not surface referenced.
1
Always sensor referenced if used upside down. Selectable from 1 to 70
meter. Default setting is 3 meter.
Number of Cells in Column 2, maximum 50 cells. Default setting is 10.
1
Spacing between two cells for Column 2 in meter. If spacing is equal to
cell size the two cells is next to each other. Spacing less than cell size
1
gives overlap and spacing more than cell size gives space between two
cells. Selectable from 0.1 to 30 meter. Default setting is 2 meter.
Enables Column 3
1
Enables surface reference for Column 3. If not selected the column will
be instrument referenced.
1
compensate for tidal variations. Cannot be used it in combination with
downward orientation.
The Cell size setting in Column 3 in meter. Selectable from 0.5 to 5
1
meter. Default setting is 1 meter.
Note! The sensor needs a pressure input to
Note! The sensor needs a pressure input to
Note! The sensor needs a pressure input to
Page 25
No /
SC
Low