Aanderaa DCPS 5400 Operating Manual page 110

Page 110
Example 3: Output from sensor when all selectable output is off
//Press Enter to start communicating with the sensor, refer chapter
↵ //press Enter
Stop
↵ // Stop current measurement. Wait for ack #. Repeat if necessary.
Set Passkey(1)
Set C1 Number Of Cells(1)
Set Select Profile Parameters(User Specified)
Set NE Speed Output(Off)
Set 3-Beam Combination Output(Off)
Set AutoBeam Output(Off)
Set Vertical Speed Output(Off)
Set Strength Output(Off)
Set Beam Speed Output(Off)
Set Beam Strength Output(Off)
Set Std Dev Speed Output(Off)
Set Std Dev Beam Speed Output(Off)
Set Cross Difference Output(Off)
Set Correlation Factor Output(Off)
Set Noise Level Output(Off)
Set Heading Output(Off)
Set Pitch Roll Output(Off)
Set Abs Tilt Output(Off)
Set Max Tilt Output(Off)
Set Tilt Direction Output(Off)
Set Std Dev Heading Output(Off)
Set Std Dev Tilt Output(Off)
Set Charge Voltage Output(Off)
Set Memory Used Output(Off)
Set Voltage Output(Off)
Set Current Output(Off)
Set Air Detect Output(Off)
Set Speed Of Sound Output(Off)
Set Depth Output(Off)
Set Salinity Output(Off)
Set Density Output(Off)
Do Refresh()
↵
Set Interval(10 sec)
Save // wait for ack #
↵
Reset // the sensor will restart with new settings
↵
Comments example 3:
The sensor always outputs some information which is not possible to disable. In this example only 1 cell is enabled just
to show the shortest possible output first, see
July 2019 – TD 304 OPERATING MANUAL – Doppler Current Profiler Sensor
↵ //wait for ack #
↵ //wait for ack #
//wait for ack #
↵
↵
//wait for ack #
↵
//wait for ack #
↵
//wait for ack #
↵
//wait for ack #
↵
//wait for ack #
↵
//wait for ack #
↵
↵
//wait for ack #
↵
//wait for ack #
↵
//wait for ack #
↵
↵ //wait for ack #
//wait for ack #
↵
↵ //wait for ack #
↵ //wait for ack #
↵ //wait for ack #
↵ //wait for ack #
↵ //wait for ack #
↵ //wait for ack #
↵ //wait for ack #
↵ //wait for ack #
↵ //wait for ack #
↵ //wait for ack #
//wait for ack #
↵
//wait for ack #
↵
//wait for ack #
↵
//wait for ack #
↵
↵
Figure 5-7.
↵ //wait for ack #
//wait for ack #
//wait for ack #
5.4