Aanderaa DCPS 5400 Operating Manual page 21

July 2019 – TD 304 OPERATING MANUAL – Doppler Current Profiler Sensor
Temperature Float
Enable Derived
BOOL
Sound Speed
Pressure Sensor Id ENUM
Pressure Parameter
ENUM
Id
Air Pressure Sensor
ENUM
Id
Air Pressure
ENUM
Parameter Id
Temperature Sensor
ENUM
Id
Temperature
ENUM
Parameter Id
Conductivity Sensor
ENUM
Id
Conductivity
ENUM
Parameter Id
ENUM
Heading Sensor Id
The temperature in degree centigrade. The value is used for
calculation of Salinity, Sound speed and Density. Can be
1
altered while sensor is running to compensate for variable
temperature.
3)
If enabled it will calculate the sound speed from the other
available sensors or fixed values. This overrides the Sound
1 Speed setting. If a parameter is available from another sensor it
will use this in the calculation, otherwise it will use the fixed
value.
When the DCPS is connected to AiCaP, a list of other available
sensors connected to the SmartGuard/SeaGuard Datalogger is
1
shown. This makes it possible to get a correct depth input from
another sensor through the datalogger
A list of all available Pressure parameters with kPa as unit is
1
shown in the dropdown menu. Make sure that the correct
pressure parameter is selected. Only in AiCaP mode.
When the DCPS is connected to AiCaP, a list of other available
sensors connected to the SmartGuard/SeaGuard Datalogger is
1
shown. This makes it possible to get a correct air pressure input
from another sensor through the datalogger
mode
A list of all available Air Pressure parameters with hPa or mbar
1
as unit is shown in the dropdown menu. Make sure that the
correct pressure parameter is selected. Only in AiCaP mode.
When the DCPS is connected to AiCaP, a list of other available
sensors connected to the SmartGuard/SeaGuard Datalogger is
1
shown. This makes it possible to get a correct temperature input
from another sensor through the datalogger
mode
A list of all available Temperature parameters with DegC or
Deg.C as unit is shown in the dropdown menu. Make sure that
1
the correct temperature parameter is selected. Only in AiCaP
mode.
When the DCPS is connected to AiCaP, a list of other available
sensors connected to the SmartGuard/SeaGuard Datalogger is
1 shown. This makes it possible to get a correct conductivity input
from another sensor through the datalogger
mode
A list of all available Conductivity parameters with mS/cm as
1
unit is shown in the dropdown menu. Make sure that the correct
conductivity parameter is selected. Only in AiCaP mode.
When the DCPS is connected to AiCaP, a list of other available
sensors connected to the SmartGuard/SeaGuard Datalogger is
1
shown. This makes it possible to get a correct heading input
from another sensor through the datalogger
mode
Only in AiCaP mode
7)
Only in AiCaP
7)
Only in AiCaP
7)
Only in AiCaP
7)
Only in AiCaP
7)
Page 21
No /
DS
Low