Aanderaa DCPS 5400 Operating Manual page 19

July 2019 – TD 304 OPERATING MANUAL – Doppler Current Profiler Sensor
Strength Limits
INT
BB
SP Stdev Limits
INT
NB
SP Stdev Limits
INT
BB
Vertical Current
INT
Limits
Cross
INT
Correlation High
Limit
Noise Limit 1 INT
INT
Noise Limit 2
Noise Limit 3 INT
Air Detect
INT
Threshold
Hardware ID 1 is Analog Board for Transducer 1 and 2. Hardware ID 2 is Analog Board for Transducer 3 and 4 and
1)
Hardware ID 3 is for Digital Board
When value exceeds the Discard Data limit, Discard Data will also be output in parameter status.
2)
Set limits 1, 2, 3 and Discard Data
strength below weak limit for broadband", default values are -40, -
44, -48 and -50. If value exceeds the limits a bit in Cell State will be
4
set. If Beam Strength Output is set a status for each individual
beam will be shown in Cell State 2. See Cell State definition in
Table 5-6.
Set limits 1, 2 and 3 for "Cell has high standard deviation for
narrowband", default values are 60, 80 and 100. If value exceeds
3
the limits a bit in Cell State 1 will be set. See Cell State definition in
Table 5-5.
Set limits 1, 2 and 3 for "Cell has high standard deviation for
broadband", default values are 10, 30 and 50. If value exceeds the
3
limits a bit in Cell State1 will be set. See Cell State definition in
Table 5-5.
Set limits 1, 2, 3 and for "Cell has High vertical current above high
vertical limit", default values are 10, 20 and 30. If value exceeds
3
the limits a bit in Cell State1 will be set. See Cell State definition in
Table 5-5.
Set high limit for "broadband cross correlation beam1-beam4,
outside cross correlation limit", default values are 0.6. If value
2
exceeds the limits a bit in Cell State1 will be set for each individual
beam. See Cell State definition in
Set limit for "High ambient noise measured on Beam1 – Beam4",
default values are -48. If Noise Level Output is enabled and value
1
exceeds the limits a bit in Record Status will be set for each
individual beam. See Record Status definition in
Set limit for "Higher ambient noise measured on Beam1 – Beam4",
default values are -38. If value exceeds the limits a bit in Record
1
Status will be set for each individual beam. See Record Status
definition in Table
Set limit for "Even higher ambient noise measured on Beam1 –
Beam4", default values are -28. If exceeds the limits a bit in
1
Record Status will be set for each individual beam. See Record
Status definition in
Set limits for air detect, default values are 500. Used to disable
ping pulse from the transducers when sensor is in air. If value
1
exceeds the limits a bit in Record Status will be set. See Record
Status definition in
for "Cell has weak signal,
2)
Table 5-5.
5-7.
Table 5-7.
Table 5-7.
FC
Table 5-7.
Page 19
High /
Read
Only