Setting Up Profinet Communications; Configuring Network Settings In The Code Reader - Omron MicroHAWK V320-F Series User Manual

4-3
Setting Up PROFINET Communica-
tions
4-3-1

Configuring Network Settings in the Code Reader

1
Launch a browser and enter http://192.168.188.2.
Google Chrome is the recommended browser.
2
The WebLink startup screen will be displayed.
3
If the WebLink startup screen does not appear, it means that communication between the code
reader and the PC has not been established. Check the following:
• Does the code reader and the PC have a proper physical (cable) connection?
• Are the respective IP Addresses on the PC and on the code reader set correctly?
Set the IP Address of the PC and perform a hardware reset of the code reader.
When turning the power on, press and hold the setup button on the code reader until its light
turns on.
For other measures that can be taken, refer to the Autofocus Multicode Reader MicroHAWK
V320-F/V330-F/V420-F/V430-F Series User Manual (Z432-E), Appendices, Q&A, How to react
when unable to connect to WebLink.
4
The WebLink screen shown below will appear.
Autofocus Multicode Reader MicroHAWK V320-F/V330-F/V420-F/V430-F Series User Manual for Communication Settings (Z407-E1)
4 Controlling Operation and Data Output with PROFINET
4
4-7