Grizzly G1014Z Owner's Manual page 25

Figure 26. G1014ZX sander fastened to cabinet
(2 of 4 hex bolts shown).
18. Slide the flat ends of the idler roller into
the slots on the roller adjustment bars (see
Figure 27).
19. Install (1)
⁄ "-20 x
1 1
4
flat washer onto each side of sander behind
idler roller (see Figure 27).
Idler Roller
x 2
Figure 27. Idler roller installed.
20. Loosen, but do not remove, the shaft set
screws on the cast iron plate so they are
backed out of the shaft hole and keyway (see
Figure 28).
Model G1014Z/G1014ZX (Mfd. Since 08/22)
x 4
⁄ " thumb knob and (1)
1
2
Figure 28. Set screw locations on sanding disc
21. Align the keyway on the plate with the drive
shaft key, then slide the plate onto the shaft,
as shown in Figure 29.
⁄ "
4
Figure 29. Installing plate onto drive shaft.
22. Adjust the cast iron plate so it protrudes
slightly (
1
the metal cover on both sides, as illustrated
in Figure 30, to avoid the possibility of
workpieces hitting the cover during sanding
operations.
Lip
Figure 30. Gap between plate and cover.
Set Screws
plate.
⁄ "- ⁄ ") beyond the curved lip of
1
16 8
(Top View)
Key
Cover
Plate
/ "- / "
1 1
16 8
-23-