Return; Disposal; Software History; Contact Addresses Of Endress+Hauser - Endress+Hauser Fieldbus levelflex M FMP 40 Operating Instructions Manual

9 Trouble-shooting
88
9.5

Return

The following procedures must be carried out before a transmitter is sent to
Endress+Hauser e.g. for repair or calibration:
• Remove all residue which may be present. Pay special attention to the gasket grooves
and crevices where fluid may be present. This is especially important if the fluid is
dangerous to health, e.g. corrosive, poisonous, carcinogenic, radioactive, etc.
• Always enclose a duly completed "Declaration of contamination" form (a copy of the
"Declaration of contamination" is included at the end of this operating manual). Only
then can Endress +Hauser transport, examine and repair a returned device.
• Enclose special handling instructions if necessary, for example a safety data sheet as
per EN 91/155/EEC.
Additionally specify:
• An exact description of the application.
• The chemical and physical characteristics of the product.
• A short description of the error that occurred (specify error code if possible)
• If necessary, give the error code.
9.6

Disposal

In case of disposal please seperate the different components according to their material
consistence.
9.7

Software history

Software version / Software changes
Date
V 01.02.00 / 04.2002 Original software.
Operated via:
– ToF Tool
– Commuwin II (from version 2.05.03)
– HART communicator DXR 275
9.8

Contact addresses of Endress+Hauser

The addresses of Endress+Hauser are given on the back cover of this operating
manual. If you have any questions, please do not hesitate to contact your E+H
representative.
Levelflex M FMP 40 with Foundation Fieldbus
(from OS 4.6) with Rev. 1, DD 1.
Documentation changes
Endress+Hauser