Omron SYSMAC CP Series User Manual page 309

Assembling Connector Hood
Assemble the connector hood as shown below.
End connected to FG
Grounding plate
Built-in RS-232C (CP2E-E/S
Wiring
When wiring the RS-232C terminal block, treat either solid or stranded wires directly.
Release button
• To make the connection, press the release button in with a small flat blade screwdriver and push
the line in while the lock is released. Remove the screwdriver and lock it inside.
• To disconnect the wiring, press the release button in with a small flat blade screwdriver and pull
the line out while the lock is released.
Note 1 Note 1 Ferrules with/without plastic sleeve cannot be used.
2 When using stranded wire, twist the core so that the barbed wires cannot protrude.
3 Do not solder-plate the end of cable.
The screwdriver shown below is recommended for wiring.
Model numbers
SZS 0.4×2.5
Side
0.4mm
CP2E CPU Unit Hardware User's Manual(W613)
Heat-shrinking tube
End not connected to FG
Aluminum foil tape
D- ) or CP2W-CIFD1/2 RS-232C
2-conductor shielded
twisted-pair cable
Manufacturer
Phoenix Contact
Front
2.5mm
Appendices
A-45