Step 8: Power On The Ptx3000 Packet Transport Router; Power On The Dc-Powered Ptx3000 Packet Transport Router - Juniper PTX3000 Quick Start Manual

PTX3000 Packet Transport Router Quick Start

Step 8: Power On the PTX3000 Packet Transport Router

Power On the DC-Powered PTX3000 Packet Transport Router

26
Figure 24: Installing an AC PSM
Repeat the procedure for the remaining PSMs.
10.
Verify that the AC power cords do not drape where people could trip on them.
11.
To power on the packet transport router, perform one of the following procedures:
Power On the DC-Powered PTX3000 Packet Transport Router on page 26
Power On the AC-Powered PTX3000 Packet Transport Router on page 27
To power on the DC-powered packet transport router:
NOTE: After powering off a power supply, you must wait at least 60 seconds
before powering it on again.
Verify that the power supply modules (PSMs) are fully inserted in the chassis and
1.
that the captive screw on the faceplate of each PSM is tightened.
Verify that an external management device is connected to one of the Routing Engine
2.
ports on the Control Board (
NOTE: The management Ethernet port labeled
Control Board is not available until after the initial software configuration.
You can monitor the startup process during the initial installation by using
devices connected to the
Turn on the power to the external management device.
3.
or ).
AUX CON
or ports.
AUX CON
Copyright © 2014, Juniper Networks, Inc.
HOST/ETHERNET on the