Table of Contents
Advertisement
Target Requirements
The USB TAP emulator automatically supports target signal levels from 1.8V to 3.3V.
NOTE
Related Documentation
This manual describes the procedures for unpacking the USB TAP emulator, setting
up USB communications, and connecting the USB TAP emulator to your target
system.
The CodeWarrior documentation explains how to install and configure the
CodeWarrior IDE and debugger.
USB TAP Users Guide
Introducing the CodeWarrior™ USB TAP Emulator
In the case of the PowerPC, for the USB TAP emulator to properly
stop and restart a JTAG/COP target processor, the QACK signal
must be pulled low. The USB TAP emulator pulls this signal low
through the JTAG/COP connector.
Related Documentation
9
Advertisement
Table of Contents
Need help?
Do you have a question about the metrowerks CodeWarrior and is the answer not in the manual?
Questions and answers