Table of Contents
Advertisement
1.12
Emergency stop switch
CAUTION!
The drilling spindle keeps turning for a short time even after actuating the emergency
stop switch depending on the preset speed.
1.12.1 Drilling table
Seats for T-slots are attached to the clamping table.
WARNING!
Risk of injury due to workpieces flying off at high speed. Securely fix the workpiece on
the drilling table.
1.13
Separating protective devices
1.13.1 Drill chuck guard
Adjust the guard to the correct height before you start working. To do this, loosen the clamping
screw, set the required height and tighten the clamping screws again.
1.13.2 Protective cover of the V-belts
A protective cover for the belt pulleys is mounted on the drilling head. There is a switch inte-
grated in the protective cover which monitors that the cover is closed.
INFORMATION
The machine cannot be started, if the protective cover is not closed.
1.13.3 Prohibition, warning and mandatory signs
INFORMATION
All warning signs must be legible. They must be checked regularly.
1.14
Personal protective equipment
For some works you need personnel protective equipment as protective equipment. These are
safety helmet,
protective glasses or face guard,
protective gloves,
safety shoes with steel toe caps,
ear protection.
Before starting work make sure that the required personnel protective equipment is available at
the work place.
CAUTION!
Soiled personal protection equipment that may be contaminated may cause illness. It
must be cleaned after each use and at least once a week.
Personal protective equipment for special works
Protect your face and your eyes: Wear safety glasses for all work where your eyes are at risk.
Wear protective gloves when handling pieces with sharp edges.
Wear safety shoes when you assemble, disassemble or transport heavy components.
EN
DQ25 | DQ32
12
Translation of original instruction
Safety
Version 1.0.1 - 2021-01-28
Hide quick links:
Advertisement
Table of Contents
