Adjusting The Handle Height; Adjusting The Handle Angle; Adjusting The Throttle Control - Toro Greensmaster eFlex 2120 Operator's Manual

Adjusting the Handle
Height
Note:
The machine is shipped with the handle
adjusted to the lowest position. The machine is
normally operated with the handle telescoped out to
its maximum height.
1. Loosen the 3 carriage bolts and nuts securing
each side of the handle in the handle clamps
(Figure 24).
Figure 24
1. Handle clamp
2. Nut
2. Pull up on the handle slowly and evenly on each
side until it is in the desired operating position.
3. Tighten the carriage bolts and nuts to lock the
adjustment.
g016851
3. Carriage bolts

Adjusting the Handle Angle

1. Remove the hairpin cotters from the handle
retainers on each side of the machine
25).
1. Hairpin cotter
2. While supporting the handle, remove the hairpin
cotters from each side and pivot the handle to
the desired operating position
3. Install the handle retainers and hairpin cotters.
Adjusting the Throttle
Control
1. Remove the console cover.
2. Loosen the 2 fasteners securing the throttle
control (Figure
1. Fasteners
20
Figure 25
2. Handle retainer
(Figure
26).
Figure 26
2. Throttle control
(Figure
g017355
25).
g027739