Toro Greensmaster eFlex 2120 Operator's Manual page 31

Figure 33
1. T-handle connector
5. Clean and dry both the battery pack and charger
connectors.
Important:
Do not use strong solvents that
will degrade the strength of the connector
plastic. Do not use dielectric grease on the
connector or battery contacts.
6. Align the positive connectors (marked with a
"+") of the charger connector and the power
supply connector and push them together until
they lock.
Recommended charging
range
Low-temperature charging
range (Reduced Current)
High-temperature charging
range (Reduced Current)
Monitoring the Charging Process
and Troubleshooting
Note:
The LCD status display displays messages
during the course of charging. Most are routine.
If there is a fault, the error indicator light will flash
amber, or light solid red. An error message will appear
in the LCD display (Figure
with the letter E or F (for example, E-0-1-1).
To correct an error, refer to
If none of these solutions correct the issue, contact an
authorized Toro distributor.
2. Main power supply
connector
0° to 45°C (32° to 113°F)
-10° to 0°C (14° to 32°F)
45° to 60°C (113° to 140°F)
32) 1 digit at a time, starting
Troubleshooting (page
Completion of the Charging
Process
When charging is complete, the battery charging
indicator light shows solid green
Disconnecting the Charger
1. Disconnect the charger T-handle connector from
the main battery power supply connector affixed
to the battery tray.
Important:
2. Place the charger T-handle and cord in a storage
position that will avoid damage.
3. Ensure that the T-handle and battery pack
connectors are clean.
4. Connect the T-handle to the battery pack
g259735
connector
5. Turn on machine power (See the Operator's
Manual) and verify battery charge displayed on
the InfoCenter matches that as stated on the
charger.
43).
31
(Figure
Do not pull on the cables
(Figure 33)
32).