Toro Greensmaster eFlex 2120 Operator's Manual page 15

Service Brake
The service brake (Figure
front side of the handle. Pulling back the lever applies
the service brake.
You must disengage the brake before you engage the
traction drive. If you operate the machine with the
brake engaged, the machine moves, but with a high
resistance and increased power consumption.
Figure 18
1. Parking-brake latch
Parking-Brake Latch
Use the parking-brake latch
service brake. Rotate the parking-brake latch toward
the brake handle to hold the service brake in place.
Pull the brake lever to release.
Note:
You cannot move the traction-control lever
while the latch is engaged.
Operator-Presence Control (OPC)
You must engage the operator-presence control
(Figure 17) before you engage the traction lever. If you
release the OPC during operation, the traction lever
returns to neutral and the machine continues to run.
18) is located on the left
2. Service brake
(Figure 18) with the
InfoCenter LCD Display
The InfoCenter LCD display shows information about
your machine and battery pack, such as the current
battery charge, speed, diagnostics information, and
more (Figure 17).
For more information, refer to
LCD Display (page
Key Switch
The key switch
and . With the brake off and the traction drive
RUN
disengaged, move the switch to the R
the InfoCenter display lights up. Turn it to the O
position and remove the key to turn off the machine.
Speed Control
The speed control
on the right, rear side of the control panel. Rotate the
throttle to regulate the machine speed.
g016853
1. F position
AST
15
Using the InfoCenter
25).
(Figure 17) has 2 positions: O
UN
(Figure 17 and Figure
Figure 19
2. S position
LOW
FF
position until
FF
19) is located
g027738