Toro Greensmaster eFlex 2120 Operator's Manual page 27

1. Alignment stripes
Operating the Machine in Low
Light Conditions
When operating in low light conditions, use the LED
Light Kit; contact your authorized Toro distributor.
Important:
Do not use other light systems with
this machine; they may damage the battery pack
or electrical system.
Operating the Controls while
Mowing
1. Start the machine, set the throttle to a reduced
speed, push down on the handle to raise the
cutting unit, press the operator-presence control,
move the traction and reel-drive engagement
lever to the F
ORWARD
transport the machine onto the collar of the
green (Figure 31).
2. Move the lever to the N
31).
Figure 30
(transport) position, and
position
EUTRAL
g251034
Traction and Reel-Drive Lever Positions
1. N
EUTRAL
2. Traction—N
reel drive—D
3. Move the lever to the traction—N
reel drive—D
4. Move the lever to the traction—F
and reel drive—E
increase the throttle speed until the machine is
traveling at the desired ground speed, drive the
machine onto the green, lower the cutting unit to
the ground, and begin mowing.
Preparing to Transport the
Machine after Mowing
(Figure
1. Drive off the green, reduce the speed to the
Z
ERO
lever to the N
machine.
2. Empty the grass basket of clippings and install
the grass basket on the mower.
27
Figure 31
3. Traction—F
(transport)
and 4. Traction—F
EUTRAL
reel drive—E
ISENGAGE
position
ISENGAGE
position
NGAGE
position, move the traction and reel drive
postion, and shut off the
EUTRAL
g000494
ORWARD
and
ORWARD
NGAGE
and
EUTRAL
(Figure 31).
ORWARD
(Figure 31),