Battery Storage Requirements; Storing The Charger; Removing The Machine From Storage - Toro Greensmaster eFlex 2120 Operator's Manual

Battery Storage
Requirements
Note:
You do not need to remove the battery from
the machine for storage.
Refer to the temperature requirements for storage in
the following table:
Temperature Requirements for Storage
Storage Conditions
Normal storage conditions
Extreme heat—1 month or
less
Extreme cold—3 months or
less
Important:
Temperatures outside of this range
will damage your battery.
The temperature that the battery are stored at will
affect their long-term life. Storage for long periods
of time at extreme temperatures will reduce the
battery life. Store the machine in a cool (not below
freezing) location.
•
Before you store the machine, charge or discharge
the battery between 40% to 60% (50.7V to 52.1V).
Note:
A 50% charge is optimal to ensure a
maximum battery life. When the battery is charged
to 100% before storage, the battery life shortens.
If you anticipate that the machine will be stored
for a longer period of time, charge the battery to
around 60%.
•
For every 6 months of storage, check the
battery-charge level and ensure that it is between
40% to 60%. If the charge is below 40%, charge
the battery between 40% to 60%.
•
You can use a multimeter to check the charge level
when the machine is off. Refer to the following
table for the amount of voltage that is equal to the
charge level:
Voltage
52.1V
51.4V
50.7V
•
After charging the battery, disconnect the
battery charger from power. Disconnect the
power connector during storage to minimize the
discharging of the battery.
•
If you leave the charger on the machine, it will shut
off after the battery is fully charged and does not
turn back on unless the charger is disconnected
and reconnected.
Temperature Requirement
-20° to 45°C (-12° to 113°F)
45° to 60°C (113° to 140°F)
-30° to -20°C (-22° to -12°F)
Charge Level
60%
50%
40%

Storing the Charger

1. Complete the procedure for
Charger (page
2. Disconnect the power supply cord from the
charger and coil it securely.
3. Examine the power supply cord thoroughly for
signs of wear or damage. Replace it if it is worn
or damaged.
4. Examine the charger thoroughly for worn, loose,
or damaged parts. To repair or replace parts,
contact your authorized Toro distributor for
assistance.
5. Store the charger with the power supply cord in
a clean, dry place where it will not be bumped or
damaged and not exposed to caustic fumes.
Removing the Machine
from Storage
1. Turn off and disconnect the charger from the
machine.
2. Connect the T-handle connector to the main
power connector.
3. Turn on the machine and wait for 20 seconds.
42
Disconnecting the
31).