Understanding The Battery Charger - Toro Greensmaster eFlex 2120 Operator's Manual

heat in the battery pack each day and reduces the
energy capacity.
•
Adjust the bed knife to reel contact to be as light
as possible. This reduces the power needed to
run the reel and increases the amount of work the
machine performs on each charge.
Understanding the Battery
Charger
Refer to Figure 32 for an overview of the
battery-charger displays and cords.
1. Error indicator light
2. USB port cover
3. AC Power indicator light
4. Battery charging indicator
light
5. Charging output indicator
light
Connecting to a Power Source
To reduce the risk of electric shock, this charger has a
3-prong grounded plug (type B). If the plug does not
fit into the wall receptacle, other grounded plug types
are available; contact an authorized Toro distributor.
Figure 32
6. LCD display
7. Select button
8. Output connector and cord
9. Power-supply cord
Do not change the charger or the power supply cord
plug in any way.
DANGER
Contact with water while operating the
machine could cause electric shock, causing
injury or death.
Do not handle the plug or the charger with wet
hands or while standing in water.
Important:
Check the power supply cord
periodically for holes or cracks in the insulation.
Do not use a damaged cord. Do not run the cord
through standing water or wet grass.
1. Insert the charger plug on the power supply cord
into the matching input power socket on the
charger.
WARNING
A damaged charger cord can cause an
electrical shock or a fire.
Thoroughly inspect the power supply
cord before using the charger. If the cord
is damaged, do not operate the charger
until you obtain a replacement.
g251620
2. Insert the wall plug end of the power supply cord
into a grounded electrical outlet.
Charging the Battery Pack
1. Park the machine in the location designated for
overnight charging.
2. Set the parking brake
3. Turn the power to the eFlex off; refer to
g251632
Off the Machine (page
4. Disconnect the T-handle connector from the
main wire harness to the main power supply
connector on the battery base
30
(Figure 18).
Shutting
24).
(Figure 33).