Electrical System Maintenance; Electrical System Safety; Servicing The Battery Pack; Shipping The Battery Pack For Service - Toro Greensmaster eFlex 2120 Operator's Manual

Electrical System
Maintenance

Electrical System Safety

•
Disconnect the battery before repairing the
machine.
•
Charge the battery in an open, well-ventilated
area, away from sparks and flames. Unplug the
charger before connecting or disconnecting the
battery. Wear protective clothing and use insulated
tools.

Servicing the Battery Pack

The only user serviceable parts in the battery pack
are the labels. If you attempt to open the main
compartment of the battery pack or the master
controller you will void your warranty. If you are
having problems with your battery pack, contact your
authorized Toro distributor for help.
WARNING
The battery pack contains high voltage which
could burn or electrocute you.
• Do not attempt to open the battery pack.
• Do not place anything in the connector
of the battery pack other than the wire
harness connector that came with the
product.
• Use extreme care when handling a battery
pack with a cracked case.
• Only use the charger designed for the
battery pack
Shipping the Battery Pack
for Service
If your battery pack requires service, contact your
authorized Toro distributor for assistance. If you must
ship the battery pack, obtain the Battery Shipping
Kit. This kit contains the proper tape, labeling, and
instructions you will need to ship the battery pack.
Important:
Failure to correctly pack and label the
battery pack for shipping can result in large fines.
Refer to the instructions included in the Battery
Shipping Kit, available for free on www.Toro.com.

Disposing of the Battery

The lithium-ion battery must be disposed of or recycled
in accordance with local and federal regulations.
Maintaining the Battery
Charger
Important:
All electrical repairs should be
performed by an authorized Toro distributor only.
The operator can perform very little maintenance other
than protecting the charger from damage and weather.
Maintaining the Battery-Charger
Cords
•
Clean the cords with a slightly damp cloth after
each use.
•
Coil the cords when not in use.
•
Periodically examine the cords for damage, and
replace them when necessary with Toro-approved
parts.
Cleaning the Battery-Charger Case
Clean the case with a slightly damp cloth after each
use.

Replacing Fuses

If the machine does not turn on, even after charging,
check the machine fuses as follows:
1. Turn off the machine and disconnect the battery
pack.
2. Remove the 8 screws securing the battery pack
cover and remove the cover.
3. Check the fuses in the fuse block
1. Fuse (30 A)
2. Fuse (3 A)
35
(Figure
Figure 36
3. Open slot
36).
g017424