Transporting The Machine To The Job Site - Toro Greensmaster eFlex 2120 Operator's Manual

a message warning that the traction lever is
engaged. If this warning does not appear, the
interlock switch needs service. Correct the
problem before operating the machine; refer to
Servicing the Traction Interlock Switch (page
36).
4. Turn off the machine and return the traction
lever to the
NEUTRAL
Checking the Brake-Interlock
Switch
1. Ensure that the kickstand is down.
2. With the machine on and the service brake
engaged (not the parking–brake latch) with
moderate force, press the OPC and engage the
traction lever (Figure
labor to overcome the brake without producing
errors on the InfoCenter LCD display. It may
display a high power consumption advisory
(smaller battery with a lightning bolt). If you get
any other advisory, correct the problem before
operating the machine.
3. With the machine on, engage the parking-brake
latch, press the OPC, and engage the traction
lever (Figure 16
should not run and you should get an advisory
on the InfoCenter panel. If not, the interlock
switch needs service. Correct the problem
before operating the machine; refer to
the Brake-Interlock Switch (page
4. Turn off the machine and return the traction
lever to the N
EUTRAL
5. Carefully lower the machine off the kickstand.
position.
16). The motor should
and Figure 17). The motor
Servicing
37).
position.
Transporting the Machine
to the Job Site
Transporting the Machine Using
Transport Wheels
Use the transport wheels to transport the machine a
shorter distance.
1. Install the transport wheels; refer to
the Transport Wheels (page
2. Ensure that the traction and reel-drive lever is in
the N position.
EUTRAL
3. Ensure that the speed control is set to Z
4. Start the machine; refer to
(page 24)
5. Tip the front of the machine up, gradually move
the traction control to the F
and use the speed control to slowly increase the
machine speed.
6. Adjust the speed control to operate the mower
at the desired ground speed and transport the
machine to the desired destination.
Transporting the Machine Using a
Trailer
Use a trailer to transport the machine a considerable
distance. Use caution while loading and unloading the
machine onto the trailer.
1. Carefully drive the machine onto the trailer.
2. Shut off the machine, engage the service brake,
and use the parking-brake latch to hold the
service brake in place.
3. Securely fasten the machine to the trailer.
Note:
You can use the Toro Trans Pro trailer to
transport the machine. For instructions on loading the
trailer, refer to your trailer Operator's Manual.
Important:
Ensure that the machine is shut off
while you transport it on a trailer, as damage
can occur to the machine if it is on during
transportation.
22
6 Installing
11).
.
ERO
Starting the Machine
position,
ORWARD