Administration > Administrative Access - Multitech MultiModem SF 100-G User Manual

Administration > Administrative Access
Use this screen to set up the password that will be used by the administrator and to set an automatic
inactivity disconnection interval.
Change Password
Old Password, New Password, Confirm Password
To change the password, enter the existing password in the Old Password field, enter the new
password into the New Password field, and confirm your new password by re-entering it into the
Confirm Password entry field. Click the Save button.
Note: You should change the password immediately after initial installation and configuration, and
also change it regularly thereafter.
Web Interface Inactivity Time Out
Time Before Automatic Disconnect
An automatic inactivity disconnection interval is part of this firmware for security purposes.
In the Time Before Automatic Disconnect entry field, enter the desired time span (in seconds) after
which you will be automatically disconnected from the Web Interface if no operations take place.
•
The default setting is 120 seconds.
•
The smallest possible setting is 30 seconds.
•
The maximum setting is 3600 seconds.
Click the Save button.
Administrative Access HTTP Port
Specify the HTTP port for administrative access. Port 80 is the default used for HTTP sessions. If you
choose to change the port number, it should be between 1 and 65535. Well known port numbers and
port numbers used by the firewall are not allowed.
Click the Save button.
Multi-Tech Systems, Inc. MultiModem® iSMS User Guide for Administrators
Chapter 4 – Using the Web Interface
Administration > Administrative Access
29