Chapter 2 - Getting Started; Cabling Your Multimodem Isms; Sf 100 Cabling - Multitech MultiModem SF 100-G User Manual

Chapter 2 – Getting Started

Cabling Your MultiModem iSMS

To use your MultiModem iSMS make the appropriate connections to PCs, a cable or xDSL modem, AC power,
and the antenna.
After your device is properly cabled, it must be configured. Basic cabling directions are included below. See
Chapter 3 for basic configurations. See Chapter 4 for advanced configurations.

SF 100 Cabling

1. Turn the power off on the PCs and the MultiModem iSMS.
2. Plug one end of a RJ-45 cable into the LAN port on the MultiModem iSMS and the other end into the
Ethernet port on a network connected PC.
3. Connect the provided power supply cable to the 9 volt power port on the back of the MultiModem
iSMS, and plug the other end into an AC power outlet.
4. Attach the cellular antenna.
Antenna Notes:
•
Be sure to locate this appliance where there is wireless coverage.
•
The antenna must be attached in order for the MultiModem iSMS to be operational.
•
Maintain a separation distance of at least 20 cm (8 inches) between the transmitter's antennas
and the body of the user or nearby persons. The product is not designed for, nor intended to be,
used in applications within 20 cm (8 inches) of the body of the user.
Multi-Tech Systems, Inc. MultiModem® iSMS User Guide for Administrators 14