Turn Signal Switch; Horn Button; Pass Button; Fuel Requirement/Refueling - Triumph Daytona 675 2014 Owner's Handbook Manual

General Information

Turn Signal Switch

When the turn signal switch is pushed
to the left or right and released, the
corresponding turn signals will flash on
and off. To turn off the turn signals,
push and release the switch.

Horn Button

When the horn button is pushed, with
the ignition switch turned to the ON
position, the horn will sound.

Pass Button

When the pass button is pressed, the
headlight main beam will be switched on.
It will remain on as long as the button is
held in and will turn off as soon as the
button is released.
Caution
The headlamp pass switch is intended
for intermittent use only. Use of the
pass switch for extended periods of
time may cause the fuse to fail
resulting in loss of
operation.
56

Fuel Requirement/Refueling

Fuel Grade

cbny
This Triumph motorcycle is designed to
run on unleaded gasoline with a CLC or
AKI octane rating (R+M)/2 of 87 or
higher. Federal regulations require that
pumps delivering unleaded gasoline are
marked 'UNLEADED' and that the Cost of
Living Council (CLC) or Anti-Knock Index
(AKI) octane rating is also displayed.
These ratings are an average of the
Research Octane Number (RON) and the
Motor Octane Number (MON).
The use of leaded gasoline is illegal in
some countries, states or territories.
Check local regulations before using
leaded gasoline.
headlamp
Note:
• If 'knocking' or 'pinging' occurs at a
steady engine speed under normal
load, use a different brand of
gasoline or gasoline which has a
higher octane rating.
P b
Caution