Scroll Button; Daytime Running Lights (Drl) Switch (If Equipped); Turn Signal Switch; Horn Button - Triumph Bonneville T100 Owner's Handbook Manual

SCROLL Button

The SCROLL button
operate the following functions of the
instruments:
Odometer functions (see page 43)
▼
Trip reset (see page 43)
▼
Clock reset (see page 44)
▼
Traction control
▼
page 50).
Daytime Running Lights (DRL)
Switch (if equipped)
Note
Daytime running lights are manually
operated. They are not automatic.
The daytime running lights or dip
beam can be selected with the Daytime
Running Lights (DRL) switch.
To select daytime running lights, push
the DRL switch forward.
To select dip beam, push the DRL switch
rearwards.
When the daytime running lights are
turned on, the daytime running lights
indicator light will illuminate in the
instrument panel.

Turn Signal Switch

When the turn signal switch is pushed
to the left or right, the corresponding
turn signals will flash on and off.
The indicators
manually. To manually turn off the
indicators, press
indicator switch in the central position.

Horn Button

When the horn button is pushed, with
the ignition switch turned on, the horn
will sound.
is used to
functions (see
can be canceled
and release the
GENERAL INFORMATION

Cruise Control Button (if equipped)

When the cruise control button is
pressed, the cruise control is on. Cruise
control remains on until the button
is pressed again to turn off the cruise
control. Cruise control can be switched
on or off at any time but it cannot be
activated until certain conditions have
been met. For more information, see
page 49.

MODE Button

The MODE button
response adjustment. Press and release
the MODE button to select one of the
different rider modes available (see
page 45 for more information).

High Beam Light

When the high beam button is
pressed the high beam will be
switched on. Each press of
the button will swap between
dip and high beam.
If daytime running lights are installed on
the motorcycle, the high beam button
has additional functionality.
If the DRL switch is in the daytime
running lights position, then press and
hold the high beam button to turn the
high beam on. It will remain on as long
as the button is held in and will turn off
as soon as the button is released.
A lighting on/off switch is not installed
on this model. The tail light and license
plate light all function automatically
when the ignition is on.
The headlight will function when the
ignition is on. The headlight will go off
while pressing the starter button until
the engine starts.
allows throttle
59