Corrosion Inhibitors; Coolant Level Inspection - Triumph Daytona 675 2014 Owner's Handbook Manual

Corrosion Inhibitors

To protect the cooling system from
corrosion, the use of corrosion inhibitor
chemicals in the coolant is essential.
If coolant containing
inhibitor is not used, the cooling system
will accumulate rust and scale in the
water jacket and radiator. This will block
the coolant passages, and considerably
reduce the efficiency of the cooling
system.
Warning
HD4X Hybrid OAT coolant contains
corrosion inhibitors and antifreeze
suitable for aluminum engines and
radiators. Always use the coolant in
accordance with the instructions of
the manufacturer.
Coolant that contains antifreeze and
corrosion inhibitors contains toxic
chemicals that are harmful to the
human body. Never swallow antifreeze
or any of the motorcycle coolant.
Note:
• HD4X Hybrid OAT
supplied by Triumph, is pre-mixed
and does not need to be diluted prior
to filling or topping off the cooling
system.
Maintenance and Adjustment

Coolant Level Inspection

Street Triple, Street Triple R and
Street Triple Rx
The expansion tank cap can be located
a corrosion
at the left hand side of the motorcycle,
adjacent to the side stand.
Note:
• The coolant level should be checked
when the engine is cold (at room or
ambient temperature).
1
chrw
1. Expansion tank
2. MAX mark
3. MIN mark
coolant, as
Position the motorcycle on level ground
and in an upright position.
Check the coolant level in the expansion
tank. The coolant level must be between
the MAX and MIN marks. If the coolant is
below the minimum level, the coolant
level must be adjusted (see page 97).
2
3
93