Abs (Anti-Lock Brake System) Indicator Light; Tire Pressure Warning Light - Triumph Daytona 675 2014 Owner's Handbook Manual

General Information
ABS (Anti-Lock Brake System)
Indicator Light
Note:
• ABS will not function if there
is a malfunction with the
ABS system and the ABS
warning light is illuminated.
When the ignition switch is turned to
the ON position, it is normal that the ABS
warning light will flash on and off. The
light will continue to flash after engine
start-up until the motorcycle
reaches a speed exceeding
(10 km/h) when it will go off.
Unless the ABS system is disabled (see
page 33), or there is a fault, it should not
illuminate again until the engine is
restarted.
If the indicator light becomes illuminated
at any other time while riding it indicates
that the ABS has a malfunction that
requires investigation.
Warning
If the ABS is not functioning, the brake
system will continue to function as a
non ABS braking system. Do not
continue to ride for longer than is
necessary with the indicator light
illuminated. Contact an authorized
Triumph dealer as soon as possible to
have the fault checked and rectified.
In this situation braking too hard will
cause the wheels to lock resulting in
loss of control and an accident.
See also Braking on page 69.
50

Tire Pressure Warning Light

The tire pressure warning
light works in conjunction with
the tire pressure monitoring
system (see page 37).
The warning light will only illuminate
when the front or rear tire pressure is
below the recommended pressure. It will
not illuminate if the tire is over inflated.
When the warning light is illuminated,
the TPMS symbol indicating which is the
deflated tire and its pressure will
first
automatically be visible in the display
6 mph
area.
1
3
chrd
1. TPMS symbol
2. Rear tire, identified
3. Tire pressure
4. Tire pressure warning light
2
4