Maintenance Summary - Care Activities - Index MS32-6.2 Operating Instructions Manual

Maintenance Summary - Care activities

It is recommended to document the maintenance activities carried out by using the appropriate
maintenance log. The maintenance log has the document number DIM013EN - 03.06.2020.
The maintenance interval is highly dependent on the production and environmental conditions of the
machine. The determination of the appropriate interval must be made by the operator.
The maintenance interval should be between once per shift and once a week!
AM010 - Checking the work area door and window pane
AM016 - Check the pressures on the machine
AM026 - Check hydraulic and lubrication systems
AM030 - Visual inspection of all fluid lines and electrical cables
AM032 - Check pre-pressure of pressure accumulators
AM035 - Replace the breathing filter at the filler neck of the hydraulic fluid tank.
AM040 - Check pneumatic system (visual inspection)
AM055 - Cleaning of the machine
AM065 - Check Stäubli robot
AM080 - Clean and lubricate chucks
AM090 - Check work area light (visual inspection)
AM100 - Clean cooling lubricant outlet on spindle carrier
AM110 - Check the window pane at the level sensor of the vacuum rotation filter
AM125 - Check coolant
AM130 - Removing clamping element holder
AM280 - Clean collets and base body
AM335 - Remove, inspect, lean and reinstall the spindle liner tubes
AM340 - Visual inspection of the fire extinguishing system
AM370 - Checking gas springs on the control cabinet door
8
Maintenance Summary - Care activities
Maintenance Instructions
DIM012EN - 03.06.2020
MS32-6.2