Jm010 - Replacing The Window Pane - Index MS32-6.2 Operating Instructions Manual

Maintenance Summary - 8 Years
JM010 - Replacing the window pane
Orientation
Requirement
Maintenance Instructions
MS32-6.2
DIM012EN - 03.06.2020
If the window pane is damaged, it must be replaced. This is
necessary regardless of the extent of damage. Even with minimal
damage, the impact resistance of the pane can no longer be
guaranteed.
For safety reasons, it is recommended to obtain the window pane
directly from the machine manufacturer or its country representative.
The window pane consists of three panes. the inner pane of tempered glass, the
central pane of polycarbonate, and the outer pane also made of polycarbonate. The
inner pane is relatively resistant to chemical substances. It can be cleaned with any
commercially available cleaning agents. Only the center pane is essential for the
impact resistance of the window pane. The polycarbonate panes are subject to
natural aging and must be replaced at regular intervals.
A sealant is used at the factory to seal the new window pane. Either Silicone 1200
of General Electric or Terostat MS 930 of Teroson. If other sealing compounds
than those described here are to be used, the equivalence must be confirmed in
writing by the manufacturer.
75