Index MS32-6.2 Operating Instructions Manual page 43

Maintenance Summary - Care activities
Maintenance Instructions
MS32-6.2
DIM012EN - 03.06.2020
2.
Base body (1) and clamping tube (6) are bonded together.
(LOCTITE
Example: Installation tool (Hainbuch)
Example: Remove clamping element holder and base body
Remove the base body (1) and clamping tube (6) using the installation tool, and
clean.
3. Check clamping tube (6), base body (1), and Glyd Rings
wear, replace if necessary.
4. Clean clamping element holder (2) and collet (3). Grease collet (oil-resistant
grease).
5. Reinstall base body (1) and clamping tube (6). Grease the base body (1) and
clamping tube/thread (6) according to the manufacturer's instructions and
screw them back into the spindle using the installation tool.
)
®
for damage and
®
39