Procedure
24
1.
Chips and projecting tools in the work area.
Cuts.
Caution
Use of personal protective equipment such as safety goggles
and gloves, and appropriate tools.
Remove chips from the work area.
2. Chip accumulation particularly in the area of thetool carriers and the work area
door.
3. Flush work area with cooling lubricant.
4. Wipe clean with rags.
5. Apply an oil film to bare metal plates.
6. Check plates for damage, repair or replace if necessary.
7. Cleaning of chip conveyor, vacuum rotation filter and clean tank. For these
containers/tanks, special attention must be paid to cleaning the
respective corners of these containers. Experience has shown that this
is where most of the debris settles.
Maintenance Summary - Care activities
Maintenance Instructions
DIM012EN - 03.06.2020
MS32-6.2