Table of Contents
Advertisement
VEHICLE CARE
8. follow any instructions provided with
the jack.
9. Raise the vehicle off the ground.
10. Remove the wheel bolts and
remove the wheel.
Wheel Fitment
1. Ensure the contact surfaces of the
wheel to be fitted and wheel hub are
clean, if not, clean as necessary.
1. Position the wheel on the hub.
2. Screw in at least 2 of the vehicle's
wheel bolts at opposite points to
retain the wheel in position onto the
hub assembly.
3. Screw in the remaining 3 wheel bolts.
208
4. Tighten all 5 wheel bolts in a cross-
wise pattern using the standard
extension and (and coded wheel bolt
adaptor if locking wheel bolts are
fitted).
5. Following manufacturers'
instructions, release the jack and
lower the vehicle to the ground.
6. Fully tighten the bolts to a torque of
N
105 Nm.
NOTE: Do not use any lubricants on
the threads of the wheel bolts.
WARNING: Dirt/corrosion on a
wheel or hub mounting, oil or
grease on the wheel bolts/hub
threads, using incorrect wheel
bolts, or the wrong tightening
torque could cause the bolts to
loosen resulting in a wheel coming
off.
Advertisement
Table of Contents
