Table of Contents
Advertisement
1. Aim the remote control towards
the HomeLink
button to
®
be programmed and hold it
approximately 2-8 cm from the
button. Do not obstruct the indicator
N
lamp on the mirror.
NOTE: If problems occur with the
programming, try again whilst in-
creasing the distance between the
remote control and HomeLink but-
tons to between 15-20 cm.
2. Press and hold both the button on
the remote control and the required
HomeLink button.
3. Do not release the buttons until the
indicator lamp has switched from
flashing slowly (approximately once
per second) to either flashing quickly
(approximately 10 times per second)
or is constantly illuminated.
– The indicator lamp constantly
illuminated indicates that the pro-
gramming has finished. Press the
programmed button twice to acti-
vate.
– If the indicator lamp flashes quickly
then the device to be programmed
may have a security function that
requires the device's programming
button on its receiver to be manual-
ly depressed.
– Test by pressing the programmed
button twice to see if the program-
ming was successful.
If you experience problems program-
ming your remote controlled item, con-
tact HomeLink® at
HomeLink.com.
Reprogramming Individual Buttons
To reprogram an individual button:
– Press and hold the button as re-
quired for approximately 20 seconds.
– Once the indicator lamp on mirror
starts to flash slowly, programming
can continue as normal as shown on
N
page 178.
NOTE: If the button to be repro-
grammed is not programmed with
a new unit, it will resume the previ-
ously saved programming.
HOMELINK
Resetting the Buttons
The buttons cannot be reprogrammed
individually. It is only possible to reset
all of the buttons at the same time.
To reset:
– Press and hold the outer buttons (1
and 3) on the mirror for approximate-
ly 10 seconds.
– When the indicator lamp changes
from a constant glow and begins to
flash, the buttons are reset and can
be reprogrammed.
®
179
Advertisement
Table of Contents
