Vertical Adjustment - Siemens MOMMOMAT 1000 Installation And Start-Up Instructions Manual

13 - 2
Fig. 2 Display at the lower part of the stand
4.
5.
NOTICE

Vertical adjustment

CAUTION
1.
NOTICE
Mammomat 1000/3000
Installation and Start-Up
Set the projection angle to 60 degrees with presetting knob (2/Fig. 1).
The preset angle is displayed for approx 3 s.
Press one of the buttons (1/Fig. 1).
The rotary motion of the swivel-arm system shall stop automatically when the
preset projection angle (both + and -) is reached and at 0 degrees.
All eight rotary motion buttons (four on either side) must be
checked. After the button has been released, the swivel-arm sys-
tem shall remain in the position set.
Before vertical adjustment of the swivel-arm system is performed,
be sure to remove the protective strips from the metal curtain, see
page 3 - 5.
Press the buttons for upward and downward movement (3/Fig. 1) of the swivel-
arm system.
The movement shall stop automatically when either end position is reached or
when the button is released.
All eight vertical adjustment buttons (four on either side) must be
checked. The switching off in upper and lower end position is
effected by switches S881 and S884 respectively.
Register 3
Checking the swivel-arm system
SP B7-230.033.07
Rev. 03 11.99
Page 2 of 4 Siemens-Elema AB
SPS-UD
13
Solna, Sweden