Case 2050M Operator's Manual page 82

Tilt
Move the control lever to the left (E) to tilt the blade to the
left.
Move the control lever to the right (F) to tilt the blade to
the right.
The blade will stop moving when the control lever is in the
HOLD (C) position. When released, the control lever will
return automatically to the HOLD position.
Angling the blade
Change the angle of the blade from side to side by moving
the thumb wheel located on the face of the joystick.
Blade shake
A blade shake feature is located on the face of the right
hand joystick. When blade shake is engaged, the ma-
chine will automatically move the tilt of the blade to shake
the blade. Press and hold the blade shake momentary
button, and the blade will shake at a vigorous frequency
until released or approximately three seconds. Leveling
must be off to engage the blade shake feature.
3 - CONTROLS AND INSTRUMENTS
3-34
4
RAPH12DOZ0081AA
5
RAPH12DOZ0082AA
6
RAPH12DOZ0082AA