Case 2050M Operator's Manual page 145

5. Measure from the body of the vertical lift cylinder to the
side of the frame at the same point (A) on both sides.
6. Adjust the turnbuckle, on the side of the smallest mea-
surement, in (retract) by 1/2 turn. Then adjust the op-
posite side out (extend) by 1/2 turn.
7. Measure again as noted in step 5 and continue until the
smallest measurement is on the opposite side.
8. If the difference between the left-hand and right-hand
measurements is now greater than it was before the
last adjustment, reverse the last adjustment.
NOTE: By reversing the last adjustment, it will make the
difference between the sides as small as possible.
9. Lower the blade to the ground and rotate the turnbuck-
les two full turns in, then reinstall the turnbuckle bolts
to hold the turnbuckles in position.
6 - WORKING OPERATIONS
6-9
12
RAIL15DOZ0035BA