Case 2050M Operator's Manual page 261

2. Remove the terminal protection caps (1) from the bat-
tery.
3. Disconnect the cables (2) from the negative terminal,
then disconnect the cables from the positive terminal.
4. Remove the screws, the washers, and retainer bracket
(3) from the battery.
5. Install a new battery of the correct voltage. Center the
battery retainer bracket (3) evenly on both batteries.
Torque the battery retainer bracket fasteners to 3.4 -
5.4 N·m (2.5 - 4.0 lb ft).
6. Clean the cables. Coat new battery terminals with
grease or anti-sulfide spray.
7. Reconnect the positive cable end to positive terminal
first. Reconnect the negative cable end to the negative
terminal.
8. Torque the battery terminal nuts to 21.5 - 24.0 N·m
(15.9 - 17.7 lb ft)
9. Install the terminal protection caps (1).
10. Turn electronic disconnect to the ON position.
7 - MAINTENANCE
7-105
2
RAIL13DOZ1700AA
3
RAIL13DOZ1702AA